Top Emergency Electricians in Davis, OK, 73030 | Compare & Call
Frequently Asked Questions
I want to upgrade my panel. What permits do I need from the City of Davis, and do you handle that?
Any service upgrade or panel replacement requires a permit from the City of Davis Building Department and a final inspection. As a Master Electrician licensed by the Oklahoma Construction Industries Board, I pull all necessary permits on your behalf as part of the job. All work is performed to the 2020 NEC code, which is the state-adopted standard. You'll receive the closed permit documentation for your records, which is essential for home insurance and future resale.
How can I prepare my Davis home's electrical system for ice storms in winter and brownouts in the summer?
For winter ice storms, ensure your generator inlet and transfer switch are installed by a licensed electrician to prevent back-feeding deadly voltage to utility workers. In summer, brownouts from high AC demand cause low voltage that can damage compressor motors. A whole-house surge protector is crucial year-round. For critical circuits, consider an automatic standby generator that kicks in during an outage, protecting your sump pump, refrigerator, and heating system.
My smart TVs and modem keep getting fried after thunderstorms. Is this an OG&E problem or my house wiring?
Frequent lightning in our area creates a high surge risk on the OG&E grid, but the final protection is your responsibility. Utility-side surges can enter your home through power lines, cable, or phone lines. Modern electronics are highly sensitive to these voltage spikes. A whole-house surge protector installed at your main panel is the primary defense, creating a barrier for your entire home. Point-of-use protectors at individual outlets provide a secondary layer of defense for your most valuable devices.
My overhead service mast looks old and the cable is sagging. Who is responsible for fixing that, me or OG&E?
The utility owns the lines up to the weatherhead, which is the curved pipe where the wires enter your house. You, the homeowner, own the mast, the weatherhead, and all wiring from that point into your meter base and panel. If the mast is leaning or the service entrance cables are sagging or damaged, that is your responsibility to repair. A compromised mast can be torn off in a storm, causing a dangerous live wire situation, so it should be addressed promptly.
We live near the limestone bluffs and get a lot of static on our landline. Could the terrain be affecting our electrical?
The rocky, limestone-heavy soil common around Turner Falls Park can create a high-resistance ground, which is critical for safety and noise reduction. A poor ground can lead to interference on phone lines, tingles from appliances, and even reduce the effectiveness of your surge protection. We often need to drive additional grounding rods or use chemical ground enhancement to achieve the low-resistance path required by the NEC. This also stabilizes voltage throughout your home.
I have a 100-amp Federal Pacific panel and want to add an EV charger. Is this safe or even possible?
A Federal Pacific panel is a known safety hazard due to breakers that can fail to trip during an overload, creating a serious fire risk. The first step is always to replace that panel with a modern, UL-listed unit. Regarding the EV charger, a 100-amp service from 1979 is typically insufficient for a Level 2 charger, which often requires a 50-amp circuit alone. Adding one would almost certainly require a full service upgrade to 200 amps to handle the new load safely alongside your existing air conditioning and appliances.
The lights went out and I smell something burning near my panel. How fast can an electrician get here?
A burning smell indicates an active fault that needs immediate attention. From our location, we can typically dispatch from the Turner Falls Park area and be in Downtown Davis via I-35 within 15 minutes for an emergency like this. The priority is to safely de-energize the affected circuit or the entire service to prevent a fire. Please turn off the main breaker if you can do so safely and call right away.
My Davis home was built in 1979 and my lights dim when the AC kicks on. Is my wiring too old?
Your electrical system is now 47 years old, and original NM-B Romex wiring in Downtown Davis homes wasn't designed for today's constant appliance loads. While the wire insulation is often still sound, the main issue is capacity. A 1979-era 100-amp panel, combined with the dozens of new devices we plug in, simply strains the system. This causes voltage drop, which you see as dimming lights. It's a sign your system is working at its limit, not necessarily that the wires themselves have failed.