Top Emergency Electricians in Great Neck, NY, 11020 | Compare & Call

For a burning smell, treat it as an emergency and shut off the main breaker if safe to do so. From our dispatch near the Great Neck LIRR Station, we can typically be en route in under 15 minutes, using I-495 for direct access to most of the peninsula. Immediate response is crucial with these symptoms to assess damage at the panel bus bars or within wall cavities before a smoldering fault escalates.

Prepare for winter ice loads by ensuring your overhead service mast and cables are secure and clear of tree limbs. For summer brownouts, a hardwired automatic standby generator, installed with a proper transfer switch, is the safest solution for backup power. Never use a portable generator indoors or by connecting it directly to your panel. These measures protect against extended outages that can damage appliances and HVAC systems.

It could be both. The PSEG grid in our coastal area faces moderate surge risk from seasonal storms, which can introduce transient voltage spikes. However, flickering or resets often point to poor connections in your older home wiring, which cannot provide the stable power modern electronics need. A professional can diagnose whether the issue originates at your service mast, within the panel, or on a specific circuit, and recommend whole-house surge protection as a baseline defense.

All major work requires a permit from the Great Neck Plaza Building Department and must comply with NEC 2020. As a master electrician licensed by the Nassau County Department of Consumer Affairs, I handle the permit application and scheduling. The final inspection is conducted by the Village's building inspector to ensure the installation meets all safety and code requirements before your utility, PSEG, will reconnect the upgraded service.

Installing a Level 2 EV charger on a 100-amp service from 1953 is not advisable and likely unsafe. The panel is already at capacity for a modern home. Furthermore, many homes in Great Neck from that period have Federal Pacific panels, which are a known fire hazard due to breakers that fail to trip. A full service upgrade to 200 amps is the required first step, which also allows for future heat pumps or other high-demand appliances.

A 73-year-old electrical system is the core issue. Your cloth-jacketed copper wiring from that era is likely brittle, with degraded insulation. Modern loads from air conditioning, computers, and kitchen appliances draw more current than this system was ever designed to handle, leading to voltage drop and overheating at connections. Upgrading the service entrance and wiring is not just about convenience; it's a critical step in preventing fire hazards inherent in aging infrastructure.

Overhead mast service, while common here, presents specific vulnerabilities. The mast itself can be damaged by falling limbs or ice accumulation, potentially pulling the service entrance cables. Weatherhead seals degrade over decades, allowing moisture into your panel. We also inspect the point where the mast meets the roof for proper flashing to prevent leaks. Ensuring this entire assembly is up to current NEC 2020 wind and ice load codes is a key part of maintaining service reliability.

Yes, the rocky, varied soil common in these coastal hills can challenge your grounding electrode system. Proper earth contact for your ground rods is essential for safety and surge dissipation. Over time, soil conditions can corrode connections or increase grounding resistance, which a licensed electrician should test. Additionally, the heavy tree canopy in these areas can cause interference and damage to overhead service lines during storms.