Top Emergency Electricians in Houma, LA, 70360 | Compare & Call
Doug's Service Company
Ben's Electrical and Handyman Services
Shockwave Generators & Electric
Coastal Mechanical Contractors
Common Questions
We have an old Federal Pacific panel. Is it safe to install a Level 2 car charger or a new heat pump?
No, it is not safe. Federal Pacific panels have a known, widespread failure risk where breakers may not trip during an overload, creating a serious fire hazard. Before adding any major load like an EV charger or heat pump, the panel must be replaced. Furthermore, your existing 100-amp service is likely insufficient for these additions; a full service upgrade to 200 amps is the standard, safe solution for modern energy needs.
How can I prepare my home's electrical system for a summer brownout or an ice storm?
For summer peaks, ensure your air conditioning system is on a dedicated, properly sized circuit to prevent overloads. Consider installing a standby generator with a proper transfer switch to maintain critical circuits during extended outages from storms or brownouts. For winter, have an electrician inspect exterior service cables and mast heads for ice load vulnerability. Whole-house surge protection is also wise given our area's lightning activity.
We're on the flat land near the Civic Center. Could that affect our home's electrical grounding?
Yes, the terrain directly impacts grounding. Our flat, coastal plain often has a high water table, which can accelerate corrosion on underground grounding electrodes like ground rods. Conversely, during dry periods, soil conductivity can drop. A proper grounding system requires driving two eight-foot ground rods at least six feet apart and bonding them correctly to your panel. An electrician should test the ground resistance periodically to ensure it meets NEC standards for safety.
Our West Houma house was built in 1973. Why do the lights dim when the air conditioner kicks on?
You have a 53-year-old electrical system. While the copper wiring is reliable, the 100-amp service panel installed in 1973 was designed for a different era. Modern homes in West Houma now use far more power for kitchen appliances, electronics, and central air. The original panel capacity simply cannot meet today's simultaneous electrical demands, leading to voltage drop, which causes dimming lights and potential circuit overloads.
My power comes from an overhead line on a mast. What should I watch for with that setup?
Overhead service masts are common in West Houma but require vigilance. Inspect the mast head and the service drop cables for weathering, corrosion, or damage from tree limbs. The mast must be securely anchored to your structure; a loose mast can strain connections and cause a fire hazard. Before any major roof work or tree trimming near the lines, contact Entergy Louisiana to temporarily disconnect the service at the pole for everyone's safety.
The power is out and I smell something burning near my breaker box. Who can get here fast?
A burning smell indicates an active electrical fault requiring immediate shutdown. From the Houma-Terrebonne Civic Center, our service trucks use US-90 for a 10-15 minute response to West Houma. Do not attempt to reset the breaker. Your priority is safety: turn off the main breaker if you can do so safely and evacuate the area around the panel until a licensed electrician arrives to assess the damage.
My smart TVs and computers keep getting fried. Is this an Entergy Louisiana grid problem?
Frequent surges damaging electronics are a common issue here. Entergy Louisiana's overhead grid across our flat coastal plain is highly exposed to lightning strikes, a primary cause of destructive power surges. While the utility manages grid-level faults, protecting your home requires a layered defense. Installing a whole-house surge protector at your service entrance is critical, backed by point-of-use protectors for sensitive electronics.
Do I need a permit from the Terrebonne Parish Permit Department to replace my electrical panel?
Absolutely. A panel replacement always requires a permit and subsequent inspection. This ensures the work complies with the current NEC 2020 code, which governs safety standards for arc-fault protection and grounding. As a Master Electrician licensed by the Louisiana State Licensing Board for Contractors, I handle all permit paperwork and scheduling with the Parish. This formal process is your guarantee that the installation is documented, safe, and insurable.