Top Emergency Electricians in Edgewood, FL,  32806  | Compare & Call

This is likely a combination of both factors. The Orlando Utilities Commission grid in our area faces high surge risk from frequent lightning, which can cause momentary dips and spikes. However, your home's internal protection is the critical line of defense. Older panels lack the whole-house surge protection needed to shield sensitive 2026 electronics. We install dedicated surge protective devices at the main service panel to clamp these external surges before they reach your outlets.

For summer peaks, ensure your HVAC system is on a dedicated, properly sized circuit and consider a hardwired surge protector for the entire house. For winter preparedness, a properly installed and permitted generator interlock kit on your panel is the safest solution for backup power during ice storms. This allows you to safely connect a portable generator without back-feeding the grid, protecting both your home and utility line workers.

Yes, the flat coastal plain and sandy soil common in Edgewood can impact grounding electrode conductivity. Sandy earth has higher electrical resistance than denser clay, which can hinder the proper dissipation of fault currents. We often need to drive grounding rods deeper or use multiple rods to achieve the low-resistance ground required by code. This ensures your surge protectors and safety systems have an effective path to earth.

Overhead service masts are common here. The main concerns are physical integrity and clearances. Inspect the mast for rust or damage where it meets the roof, and ensure tree branches are trimmed well back from the service drop lines. In a suburban setting, the main panel is typically located where the mast enters the house, often in a garage or laundry room. This area must remain clear for safe access by you and utility personnel.

All panel upgrades in the City of Edgewood require a permit from the Building Department and a final inspection. The work must be performed by a licensed contractor, as regulated by the Florida Department of Business and Professional Regulation, and it is mandated to comply with the Florida Building Code, which currently adopts the NEC 2023. As your Master Electrician, I handle the permit paperwork and ensure the installation meets all updated code requirements for AFCI protection, grounding, and load calculations.

This is a two-part safety issue. First, Federal Pacific panels have a known failure rate and are no longer considered safe for continued use; replacement is strongly advised. Second, a 100A service from 1978 lacks the capacity for a Level 2 EV charger or a modern heat pump system. A full service upgrade to 200A is the necessary foundation, which then allows for the dedicated circuits and AFCI protection these new loads require under the current code.

Your home's electrical system is now about 48 years old, and NM-B Romex from that era was designed for a different set of loads. Modern kitchens, home offices, and entertainment centers demand far more power than what a 1978 panel and circuits were engineered to handle. The 100A service, once standard, can be easily overwhelmed by today's simultaneous use of high-draw devices, leading to frequent breaker trips and potential overheating in undersized wiring.

For an urgent situation like that, we prioritize immediate dispatch. From our start point near Edgewood City Hall, we use I-4 for quick access across the city, typically arriving in the Edgewood Forest neighborhood within 5 to 8 minutes. Your first action should be to safely exit the home and call us from outside; a burning odor often indicates a serious fault at the main panel that requires professional isolation.